A soft top picks up traffic film, tree sap, bird droppings and ingrained dirt, and over time that grime dulls the colour and can hold moisture against the fabric. Cleaning it properly is the foundation of every other job, from reproofing to reviving the colour. Done the wrong way, with a pressure washer or harsh chemicals, it can cause damage that can’t be undone. Here’s how to do it safely using Renovo’s dedicated soft top cleaners.
First, make sure you know whether your roof is fabric or vinyl, as each needs its own cleaner. If you’re not sure, read Is My Convertible Soft Top Fabric or Vinyl? How to Tell.

The Short Answer
- Work on a cool, dry roof out of direct sunlight.
- Brush off loose dirt, mist the roof with water, then brush on the correct Renovo cleaner with a 5cm (2”) paintbrush.
- Leave it for 10–20 minutes, agitate gently with warm water and a sponge, cloth or bristle brush, then rinse thoroughly.
- Never pressure wash a soft top, and don’t use car shampoo, detergents or traffic film remover on fabric.
- Cleaning removes old protection along with the dirt, so reproof once it’s dry.
What Not to Do
- Don’t use a pressure washer. Renovo says high-pressure water can damage the fabric and seams. It warns that a jet wash can blow the pile off a fabric hood, leaving white marks that are irreversible, and that jet washers will damage both fabric and vinyl soft tops.
- Don’t use car shampoo, detergent-based cleaners or traffic film remover on fabric. Renovo says harsh cleaners like these can damage fabric and seams and strip away water-repellent coatings.
- Don’t use the wrong cleaner. Fabric Soft Top Cleaner isn’t for vinyl, and Vinyl Soft Top Cleaner isn’t for fabric.
- Don’t work in direct sun or on very hot days. The product can dry too quickly and leave uneven results.
- Don’t let the cleaner dry on the fabric.
- Don’t dilute or mix the cleaner with other products.
- Don’t scrub harder to shift stubborn dirt. Renovo’s advice is to repeat the clean rather than increase the force on the fabric.
What You’ll Need
What you’ll need to clean a soft top
- Renovo Fabric Soft Top Cleaner (500ml or 1 litre) for fabric, or Renovo Vinyl Soft Top Cleaner (500ml) for vinyl
- a clean, dry brush to remove loose dirt
- a fine water spray or mister
- a clean 5cm (2”) paintbrush and a clean container
- a sponge, cloth or soft bristle brush, and a bucket of warm water
- a hose or watering can for rinsing (never a pressure washer)
- a soft, damp cloth and protective gloves
Renovo’s guide for fabric roofs: 500ml suits smaller soft tops such as two-seaters, while 1 litre suits larger roofs, or heavily soiled and mouldy soft tops that may need repeated cleaning.
Best Conditions for Cleaning
Pick a dry, mild day and work in the shade. Renovo’s guidance for its fabric products is a day that isn’t too hot and is above freezing, with 13–18°C ideal. Don’t work on a roof that has been sitting in full sun. If it’s warm to the touch, let it cool first. And because a deep clean removes the old surface protection, check the forecast: you’ll want a dry spell afterwards to let the roof dry and then reproof it.
How Long Does It Take?
| Step | Time (Renovo guidance) |
|---|---|
| Apply cleaner and leave it to work (fabric) | 10–20 minutes; 40–60 minutes for stubborn dirt or to help remove old waterproofing; up to an hour on heavily soiled roofs |
| Apply cleaner and leave it to work (vinyl) | 10–20 minutes (less for a quick clean); 40–60 minutes for stubborn dirt |
| Bird droppings and difficult stains | Leave the cleaner on the stain for 30 minutes, then rinse |
| Heavy mould on fabric | Leave for about an hour, then scrub with hand-hot water. Renovo says the job can usually be done in less than a day |
| Drying before you proof (fabric) | Allow a good 24 hours |
How to Clean a Fabric Soft Top, Step by Step
Renovo Fabric Soft Top Cleaner is made for canvas, double duck and mohair roofs of all colours. It removes grime and ingrained dirt without impairing the appearance of the fabric. Test it on an inconspicuous area first to check your roof is colourfast.
- Brush the roof while it’s dry. Gently brush away loose dirt, dust, leaves and debris with a clean, dry brush.
- Dampen the fabric. Mist the whole roof with clean water using a fine spray, or dampen it with a sponge. It should be evenly damp rather than saturated.
- Shake and pour. Shake the bottle well and pour the cleaner into a clean container.
- Brush it on. Using a clean 5cm (2”) paintbrush, apply an even coat with smooth strokes, starting at the centre and working out to the edges.
- Leave it to work. 10–20 minutes for general cleaning gives the formula time to penetrate the woven surface and loosen embedded dirt. Allow longer for heavily soiled roofs (see the table above), but don’t let it dry on the fabric.
- Agitate gently. Using warm water and a sponge, cloth or bristle brush, work across the surface until the cleaner begins to lather and the dirt lifts easily. You don’t need aggressive scrubbing: let the cleaner do the hard work, and take care around stitched areas and windows.
- Rinse thoroughly with clean water until all the cleaner and loosened dirt has gone.
- Repeat if necessary. Fabric Soft Top Cleaner can be used as often as required.

Bird Droppings, Tree Sap and Stubborn Stains
Deal with bird droppings as soon as you can. For fabric, Renovo recommends dabbing or pouring the cleaner directly onto the stain, working it into the affected area, leaving it for 30 minutes and rinsing. For bird droppings, tree sap and particularly stubborn areas, treat them first, before you clean the whole roof, and allow extra dwell time. Repeat the treatment rather than scrubbing harder.
On vinyl, dab the cleaner onto the stain, massage it in and clean it off after 30 minutes. Repeat if necessary.
Mould and Green Growth
Renovo’s recommended method for a mouldy fabric roof is Fabric Soft Top Cleaner applied to the whole hood with a clean 5cm paintbrush, left for an hour to soak into the fibres, then scrubbed with a soft bristle brush and hand-hot water (taking care not to burn yourself, and being careful around stitched areas). Rinse thoroughly and repeat until you’re happy with the result. A heavily mouldy or green roof may need several treatments, so it’s worth having enough cleaner before you start.
Be aware that if mould has taken root deep in the fabric, it can leave scars. Renovo says this is very common, and that Soft Top Reviver can help mask areas that have lost colour once the roof is clean.

How to Clean a Vinyl Soft Top, Step by Step
Renovo Vinyl Soft Top Cleaner cleans and rejuvenates vinyl roofs, removes stubborn ingrained grime and dirt, and prepares the surface for Vinyl Protector. Test it on an inconspicuous area first to check the vinyl is colourfast.
- Shake the bottle well and pour into a suitable container.
- Apply with a clean 5cm (2”) paintbrush (or a sponge) using even strokes, from the centre out to the edges.
- Leave it for 10–20 minutes (less for a quick clean) so it can work into the grime and stains.
- Scrub with warm water and a sponge, cloth or bristle brush until it lathers and the dirt visibly lifts.
- Rinse with water, and repeat if necessary.
For heavily soiled vinyl, leave the cleaner on for longer (Renovo’s guidance is up to 40–60 minutes) and use a bristle brush for more scrubbing power.
Fabric vs Vinyl: What’s Different
| Fabric | Vinyl | |
|---|---|---|
| Apply with | A clean 5cm (2”) paintbrush, after misting the roof with water | A clean paintbrush or a sponge |
| Standard dwell time | 10–20 minutes | 10–20 minutes (less for a quick clean) |
| Heavily soiled | Up to an hour | Up to 40–60 minutes, with a bristle brush |
| Next step | Revive if faded, then proof with Fabric Soft Top Protector | Protect with Vinyl Soft Top Protector once dry |
After Cleaning: Protect It
Renovo makes an important point here: a deep clean removes the old surface protection along with the dirt. So once you’ve cleaned the roof, it needs to be re-protected and weatherproofed. Let it dry fully first, then assess it:
- Fabric that’s clean but still faded: don’t keep cleaning it. Cleaning removes dirt but can’t replace lost colour. Use Renovo Fabric Soft Top Reviver before you proof. See How Can I Restore a Faded Convertible Soft Top?
- Fabric that looks good: apply Renovo Fabric Soft Top Protector. Renovo recommends allowing a good 24 hours to dry after cleaning. See Why Is My Car Soft Top Leaking Water? for the full method.
- Vinyl: once dry, apply Renovo Vinyl Soft Top Protector. The Renovo Vinyl Soft Top Maintenance Kit gives you the vinyl cleaner and Ultra Proofer together.

How Often Should I Clean It?
Both Renovo cleaners can be used as often as required. Deal with bird droppings and sap promptly, brush off leaves and debris rather than leaving them to sit, and give the roof a full clean before each protection treatment. Renovo’s general guide is to clean and protect your soft top at least twice a year, about every six months, and more often if the car lives outside or sees harsh weather. If you’re also getting water inside the car, read Why Is My Car Soft Top Leaking Water?
Renovo also has a handy tip for fabric roofs between cleans: once the hood is completely dry, the suction nozzle of a vacuum cleaner will lift dust out of the fabric.
FAQs
Can I put my convertible through a car wash or use a pressure washer?
Don’t pressure wash the roof. Renovo says jet washers should never be used on a hood because the water is too powerful and will damage both fabric and vinyl soft tops. Clean the roof by hand with the correct Renovo cleaner instead.
Can I use normal car shampoo on a fabric roof?
Renovo advises against ordinary car shampoo or detergent-based cleaners on fabric convertible roofs. Use Fabric Soft Top Cleaner, which is made to lift dirt from the woven surface.
Will cleaning fade the colour?
Test on an inconspicuous area first to check the roof is colourfast. Fabric Soft Top Cleaner is designed to remove grime without impairing the appearance of the fabric and is suitable for all colours.
Do I need to mask the paintwork and windows?
Renovo says it isn’t really necessary, as its products are water based and splashes can be wiped off with a soft, damp cloth while still wet. Masking does no harm if it makes you feel more comfortable.
My roof has white marks after a jet wash. Will cleaning fix them?
Unfortunately, Renovo says white marks from a jet wash are usually where the pile has been blown off the fabric, which is irreversible. Reviver is likely to make those marks stand out more. Marks over the roof bars, by contrast, are often fold or scuff marks, which a clean and Reviver can freshen up, although they tend to return with use.
Not sure which product suits your roof? Get in touch with the DIY Refurb team and we’ll point you in the right direction.

